AC Gas Filling in Bahria Town Lahore All Refrigerant Types Covered
Your AC is running, but the room just isn’t getting cold. Nine times out of ten, that’s a refrigerant problem. MR FIXIO provides safe, accurate AC gas filling across Bahria Town Lahore. Correct gas type, correct pressure, correct result.
Our Process
How AC Gas Filling Works With MR FIXIO
Schedule Your Appointment
Call WhatsApp or us with your AC brand, model, and issue. We'll confirm your appointment on the same day for most areas of Bahria Town Lahore
Enjoy the Results
Your AC is tested at different temperature settings before we leave. Cooling performance confirmed. The room reaches the target temperature. Done right, not just done.
Meet Your Technician
A trained AC gas technician handles the recharge using proper equipment vacuum pump, manifold gauges, and calibrated refrigerant cylinders. No guesswork. The correct amount of refrigerant is added by pressure reading, not by feel.
Get a Personalised Quote
Our technician arrives, connects a manifold gauge set to check the current refrigerant pressure, and provides you with a clear quote. You'll know exactly what type of gas your AC uses, how much is needed, and what it costs before anything starts.
Facing any of these issues? Get same-day AC repair in Bahria Town.
Signs Your AC Needs Gas Filling in Bahria Town
Most homeowners don’t realise their AC has a gas problem until it stops cooling completely. But there are earlier warning signs, and catching them early saves money.
Refrigerant (commonly called “AC gas”) is the substance that makes cooling possible. It circulates through the compressor, condenser coil, expansion valve, and evaporator coil, absorbing heat from your room and releasing it outside. When the refrigerant level drops due to a leak, this cycle breaks down. The AC runs, fans spin, electricity is consumed, but the room stays warm.
SERVICE DETAILS
What Our AC Gas Filling Service Includes
Refrigerant Pressure Check
Before adding any gas, we connect a manifold gauge set to measure the current pressure in your system. This tells us exactly how much refrigerant has been lost and confirms what type is needed — R22, R32, or R410A. Adding gas without checking pressure first leads to overcharging, which damages the compressor.
Leak Detection & Location
Gas doesn't disappear it leaks. We inspect the refrigerant circuit: joints, flare connections, service valves, copper pipe bends, and the indoor and outdoor coil. We use soapy water, UV leak detection fluid, or an electronic refrigerant detector, depending on the situation. Finding the leak first prevents the same problem from happening again in a few months.
Refrigerant Leak Repair
If a leak point is found, a loose flare fitting, a pinhole in the copper pipe, or a cracked valve we repair it before refilling. Filling gas into a leaking system is a waste of money. We fix the source, then recharge.
Refrigerant Recharge
Using calibrated refrigerant cylinders, we recharge your system to the correct pressure as specified by your AC manufacturer. We work with: R22 (Freon) — older split and window AC units R32 — newer Gree, Haier, Dawlance, Kenwood inverter ACs R410A — Samsung, LG, Mitsubishi and some other brands Correct gas type matters. Using the wrong refrigerant damages your compressor and voids any manufacturer warranty
Post-Fill Performance Test
After recharging, we run the AC and measure the temperature differential between air entering and leaving the indoor unit. A properly charged system should show an 8–12°C temperature drop across the evaporator. We confirm this before leaving — not just assume it's working.
Gas Filling for All AC Types
We provide refrigerant recharge for all common AC types in Bahria Town homes: Split AC (inverter and non-inverter) Window AC Cassette AC Floor-standing AC Portable AC units
Why You Should Never Let an Unqualified Person Fill Your AC Gas
In Bahria Town and across Lahore, it’s common to see AC mechanics who offer gas filling at suspiciously low prices sometimes from the back of a motorcycle with an unmarked cylinder. This approach causes real damage that costs far more to fix later.
Wrong refrigerant type
R22, R32, and R410A are not interchangeable. Mixing refrigerants — or using the wrong type — causes chemical reactions inside the system, breaks down the compressor oil, and can permanently seize the compressor. A compressor replacement costs PKR 15,000–40,000 or more. The wrong gas costs a fraction of that — until it destroys your unit.
Overcharging the system
Adding too much refrigerant is just as damaging as too little. Overcharging increases head pressure in the compressor, causes liquid refrigerant to enter the compressor (called liquid slugging), and leads to compressor failure. Proper gas filling requires manifold gauges, not guesswork.
Ignoring the leak
Low refrigerant always means there's a leak somewhere. Filling gas without finding and repairing the leak means you'll lose the refrigerant again within weeks — and pay for another refill that also won't last.
No post-fill testing
Without measuring actual cooling performance after a refill, there's no way to confirm the job was done correctly. An undertrained mechanic fills gas, packs up, and leaves. Two days later, the problem is back.
Why Bahria Town Homeowners Choose MR FIXIO for AC Gas Filling
Same-Day Service Available
Call us in the morning and get your AC gas refilled the same day across all sectors of Bahria Town Lahore. We don't make you wait days for a booking.
Correct Refrigerant
We identify your AC model and manufacturer specifications before touching the gas. R22, R32, or R410A is the right refrigerant, the right quantity, the right pressure.
Leak Detection Included
We don't just refill and leave. Every gas filling service includes a leak inspection so you're not back to square one in two weeks.
Transparent Pricing
You'll know the cost of gas filling, any repair needed, and the total amount before a single valve is opened. No additions at the end.
Trained Technicians
Manifold gauges, calibrated cylinders, vacuum pumps — our technicians work with proper tools. AC gas handling without correct equipment is guesswork at best, dangerous at worst.
- Bahria Town Sector A
- Sector B
- Sector C
- Sector D
- Overseas Enclave
- Usman Block
- Talha Block
- Ali Block
- Jasmine Block
- Rafi Block
- Maraka Village
- Sukh Chayn Gardens
- Dream Gardens
- Izmir Town
- Wapda Town
- Canal Garden
- Jubilee Town
- Valencia Town
- NFC Society
FAQ Question
Frequently Asked Questions
The cost depends on the refrigerant type and how much is needed. R22 gas filling typically costs PKR 2,500–4,000. R32 and R410A are slightly higher, usually PKR 3,500–6,000 because these are newer, more expensive refrigerants. If a leak repair is also needed, that’s quoted separately before we proceed. We always give you the full picture before starting.
The clearest sign is an AC that runs normally — compressor on, fans spinning — but doesn’t cool the room. If your electricity bill is high but your room isn’t getting cold, low refrigerant is the most likely cause. Our technician will connect gauges to confirm refrigerant pressure. If pressure is fine, we’ll check other possible causes — dirty coils, airflow issues, or electrical faults.
The gas filling itself takes 20–40 minutes once the technician is on site. If a leak is found and needs repair first, add another 20–45 minutes depending on the location of the leak. Total visit time including inspection, repair if needed, filling, and testing is usually 1–1.5 hours.
A properly sealed AC system should never need a gas refill under normal use. Refrigerant isn’t consumed like fuel; it circulates in a closed loop. If your AC regularly needs gas, it means there’s a leak somewhere that hasn’t been properly fixed. We find and repair leaks so you’re not calling us back every summer.
It won’t immediately harm people, but it damages your AC significantly over time. A compressor running without adequate refrigerant overheats, loses lubrication, and eventually fails. Compressor replacement is expensive, PKR 15,000 to 40,000 or more. Getting the gas filled early is far cheaper than replacing a burned-out compressor.
Yes, if the installation was done poorly. During AC installation, flare connections must be tightened to specification and the system must be vacuumed before gas is added. If the installer skipped vacuuming, didn’t tighten connections correctly, or damaged the copper pipe during installation, gas can leak from day one. We check installation quality as part of our diagnosis.